Repair of azimuthal orientation - 7th of Februari

During the assembly of the cavity on 20th of September 2006 in Eindhoven we discovered that there was an azimuthal mismatch between the cavity orientation and the flange of the stainless steel vacuum container (see foto 1 and 2).

The solution was to replace the fitting pin with a new one having an offset. Last week we installed this new pin. The last photo shows that the replacement was successful. Now both the cooling channel and all the bolts fit correctly.


1- Assembly in Eindhoven in September 2006
2- The mismatch between the cavity and SS container.

3- The new fitting pin.
4- Correct assembly.